The biggest difference between the integrated pumping station and the traditional concrete pumping station is that it can complete the production and part processing of the entire equipment before leaving the processing plant, and then transported to the project site for final installation. This mode of operation greatly shortens the construction cycle time and saves a lot of cost budgets. At present, domestic assembled integrated sewage treatment plants are mainly used for wastewater upgrading and sewage treatment in municipal engineering, living, local and other occasions. It can refer to low-lying land or underground wastewater and pass it to urban sewage treatment stations for effective conversion and removal of air pollutants in wastewater.
China is improving the construction of sponge cities. The main drainage equipment used in the construction is the integrated pumping station, because it has a short construction period and has the advantages of convenient maintenance, high cost, and high drainage rate. State E has a set of strict product standards for integrated pumping stations. In production, each manufacturer must comply with these standards. The pump cylinder of this sewage treatment plant is made of composite winding FRP anticorrosion, including embossed aluminum plate drain cover, FRP anti-corrosion safety Geshan, 316 stainless steel plate operation platform, 316 stainless steel plate ventilation duct, 316 stainless steel plate ladder ladder and 30 stainless steel Board manhole. Desilting design of river channel at the bottom of fault block.
In the manufacture of FRP anticorrosive round tanks, our factory adopts the continuous winding process of machine command coiling and computer control to make the whole round tank more high quality and cheaper. At the same time, the anti-corrosion performance of the gas cylinder was tested to enable it to self-regulate acidic and alkaline alkaline wastewater treatment. According to a certain standard, the die-casting mold of the sewage treatment plant is combined with an effective epoxy resin ratio, and the multi-layered high-rise machine is wound and laid to the required thickness after condensation. It is the final product of the sewage treatment plant cylinder. The regularity of plant fiber can be designed according to the shear force of the product, and the compressive strength of plant fiber can be fully adjusted. The modernization, high degree of mechanical automation, stable product quality, and improved compression molding at the bottom of sewage treatment plants. There is no air bubble, no block in the north of the machine command, and the needle roller bearing has the same compressive strength. The designed CFD base has the same suppression process and equipment conditions. The former uses impregnated cloth as the material of rubber and plastic products, and the other uses plastic sheet, mass and weight rubber and plastic products. First, a sufficient amount of extrusion molding material is added to the metal die-casting mold, and then the required carbon fiber products are formed at a certain temperature and pressure. The product produced by this method has accurate specifications, smooth surfaces, fast production speed, and stable product quality . This article links: http://yuedongzs.cn/gs/377.html